Dynalfocal mount installation
Posted: Sun Feb 19, 2012 4:10 pm
Was trying to do my engine mount today, and see that these dynafocal ones
are not as easy to do as my old conical mount. Is there a trick to getting
the four bolts in to the engine and compressing the barry mounts. I find
that I can get a couple in first, but then the others don't fit. Do I have
to tighten two of them all the way before the other bolts will fit the
holes?
Also, does anyone know the correct AN bolt size? I know they are 7/16, but
until I can compress the rubbers, it's hard to determine the final length. I
am just fitting it with temporary hardware bolts for now.
Walter
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
are not as easy to do as my old conical mount. Is there a trick to getting
the four bolts in to the engine and compressing the barry mounts. I find
that I can get a couple in first, but then the others don't fit. Do I have
to tighten two of them all the way before the other bolts will fit the
holes?
Also, does anyone know the correct AN bolt size? I know they are 7/16, but
until I can compress the rubbers, it's hard to determine the final length. I
am just fitting it with temporary hardware bolts for now.
Walter
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------