[rebel-builders] SR/Moose flaperon setup
Posted: Sun Feb 19, 2012 4:10 pm
Tom,
Have you tried SR-Moose files section 112 on the web sight? Several
systems are shown perhaps you can glean a bit of information from them.
Dick Wampach SR-108
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf of
Tom Packard
Sent: Tuesday, November 27, 2007 7:38 AM
To: rebel-builders-d@dcsol.com
Subject: [rebel-builders] SR/Moose flaperon setup
Question for those with completed SR/Moose planes. I'm trying to mount
my Tru Trak AP roll servo between the two aileron push tubes near the
cabin top. It requires a small bracket mounted to the slider so that
the forward end of the CC-149 center control tube is lowered about
1-1.5". This will allow it to clear the bottom of the servo. However,
to position the servo correctly so that the capstan drive is centered
with no flaps, I need to know where the slider is positioned with no
flaps and how much it moves forward toward the stop with full flaps. My
wings aren't mounted and I have not mounted the main control tube
assembly. Can anyone give me an idea of where the slider is positioned
(gap between the forward end of the slider and the stop) with no flaps
and what distance it moves forward with full flaps?
Thanks for any input on the subject.
Tom Packard
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Have you tried SR-Moose files section 112 on the web sight? Several
systems are shown perhaps you can glean a bit of information from them.
Dick Wampach SR-108
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf of
Tom Packard
Sent: Tuesday, November 27, 2007 7:38 AM
To: rebel-builders-d@dcsol.com
Subject: [rebel-builders] SR/Moose flaperon setup
Question for those with completed SR/Moose planes. I'm trying to mount
my Tru Trak AP roll servo between the two aileron push tubes near the
cabin top. It requires a small bracket mounted to the slider so that
the forward end of the CC-149 center control tube is lowered about
1-1.5". This will allow it to clear the bottom of the servo. However,
to position the servo correctly so that the capstan drive is centered
with no flaps, I need to know where the slider is positioned with no
flaps and how much it moves forward toward the stop with full flaps. My
wings aren't mounted and I have not mounted the main control tube
assembly. Can anyone give me an idea of where the slider is positioned
(gap between the forward end of the slider and the stop) with no flaps
and what distance it moves forward with full flaps?
Thanks for any input on the subject.
Tom Packard
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------