The Murphy Builders Site

I'm just starting my 1800 amphib floats are there any places I need to reinforce or any skins I need increase the thikness of? Any other advice from you amphib float opperators out there.

Si. 555R N431SS



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

At one time I talked to someone or read about machining FL230 pivot block on the front gear 2 or 3 degrees to give the pivot shaft a negative angle. I sure would like any input I could get on this. Thanks in advance.

Si



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------