To Drill or Not to Drill...
Posted: Sun Feb 19, 2012 4:05 pm
I thought I read somewhere in the archives that when MAM has you drill holes
at points where you'll be bending channel/metal, etc, it's just another
place where a tear could start. In the fin section when you build ribs, the
directions say to drill holes in each side and then fold them up around a
piece of wood. Is that a good way or is it better to just make relief cuts
and then bend? Craig
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
at points where you'll be bending channel/metal, etc, it's just another
place where a tear could start. In the fin section when you build ribs, the
directions say to drill holes in each side and then fold them up around a
piece of wood. Is that a good way or is it better to just make relief cuts
and then bend? Craig
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------