Torque Tube holes

[Hibbs]

Doug, I used the same method as Bob did. The spacing is a little more
than 7/8" between holes (actually .884").

--
Best Regards,

Scott Hibbs
hibbs@pacifier.com


Doug, The method I used to drill the tube holes was to wrap a 1" wide
piece
of paper around the tube, mark the overlap, remove and lay flat. This is
now
the circumference of the tube. Run a line down the center which is now
the
1/2" required from the end, mark the line into even (8) distances and
retape
onto the tube and &quotdrill away". I actually made many of these
templates for
all tube ends.-Bob J &quotREBEL 652"
----- Original Message -----

*---------------------------------------------------------------------------

--------*

From: &quotSnader, Douglas E." &ltsnaderde@tvfr.com>
To: "'murphy-rebel@dscol.com'" &ltmurphy-rebel@dscol.com>
Subject: drilling holes in a tube

I have one more question what is the best way to measure and mark

the

torque tubes for drilling the eight evenly spaced holes?

*-----------------------------------------------------------------------------------*
The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*-----------------------------------------------------------------------------------*




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------