rudder hinge bearings
Posted: Sun Feb 19, 2012 12:19 pm
I bought a sheet of 1/16" nylon sheet and cut 1" discs out of it with a hole saw. The hole saw had a 1/4" drill/pilot and all it took was filing the "fuzz" off the edge and central hole.
Ralph Baker
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Ralph Baker
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------