poly fibre questions
Posted: Sun Feb 19, 2012 12:12 pm
in reviewing the poly fibre book i have a couple of questions
page 26 shows how to do the 1st coat of poly brush using a paint brush, but
it never talks about a 2nd brush coat, then latter in manual there is a 1st
and second spray coat of poly brush, do i have to spray these coats, i dont
have spray equipment and dont want to go buy it
what about aluminum prep for fabric covering, manual says to clean with acid
etch and brightener, then conversion coating, then spray with epoxy primer,
is everone doing this or just scotch bright pads on the surface to clean it
throughly and then mek or lacquer thinner
thanks
mike
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
page 26 shows how to do the 1st coat of poly brush using a paint brush, but
it never talks about a 2nd brush coat, then latter in manual there is a 1st
and second spray coat of poly brush, do i have to spray these coats, i dont
have spray equipment and dont want to go buy it
what about aluminum prep for fabric covering, manual says to clean with acid
etch and brightener, then conversion coating, then spray with epoxy primer,
is everone doing this or just scotch bright pads on the surface to clean it
throughly and then mek or lacquer thinner
thanks
mike
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------