[rebel-builders] windscreen retainer
Posted: Sun Feb 19, 2012 12:12 pm
On my Elite, I made a fibreglass cuff all round - i.e. lower edge and sides.
You might want to consider a wider retainer than the Murphy supplied one
across the top of the cabin. I know of at least one that popped out, and
apparently there were some controllability problems when it did.
Al Hepburn
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com]On Behalf Of
Jones, Michael
Sent: Monday, July 09, 2007 3:09 PM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] windscrean retainer
so with the murphy supplied metal top and side retainer brackets which side
is over window, the narrow or the wide side
also i assume no holes should go through the wind screan and munting screws
only go through the metal retainer brackets
thanks
mike#007
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
You might want to consider a wider retainer than the Murphy supplied one
across the top of the cabin. I know of at least one that popped out, and
apparently there were some controllability problems when it did.
Al Hepburn
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com]On Behalf Of
Jones, Michael
Sent: Monday, July 09, 2007 3:09 PM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] windscrean retainer
so with the murphy supplied metal top and side retainer brackets which side
is over window, the narrow or the wide side
also i assume no holes should go through the wind screan and munting screws
only go through the metal retainer brackets
thanks
mike#007
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------