[rebel-builders] Aileron Slide Block Position
Posted: Sun Feb 19, 2012 12:12 pm
Mike if I am understanding what you are asking. The slider block goes
even with the bulkhead or flush with ends of channels as channel ends were
to be flush with the bulkhead that the aluminum plate is fastened to on each
end (or another way of saying 3/4 of an inch in from the end of the plate at
the rear). Clear as mud I know.. If you need more info let me know will be
here waiting on prop to be delivered.. So I can hopefully make Oshkosh..
Dale N269DF
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
even with the bulkhead or flush with ends of channels as channel ends were
to be flush with the bulkhead that the aluminum plate is fastened to on each
end (or another way of saying 3/4 of an inch in from the end of the plate at
the rear). Clear as mud I know.. If you need more info let me know will be
here waiting on prop to be delivered.. So I can hopefully make Oshkosh..
Dale N269DF
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------