Installing Fife hoerner tips
Posted: Sun Feb 19, 2012 12:12 pm
Starting to install tips. If I line up the upper surface of the tip with the
top of the wing (top of tip horizontal spanwise) then the trailing edge
angles down if you sight along trailing edge of flaperon and tip. Fife's
instructions say to use a straightedge along the top of the wing and tip. I
like the look of a straight trailing edge, and think it will look funny if
the tips sag at the trailing edge. Has anyone else had this issue?
Thanks.
Jesse
_________________________________________________________________
Get a preview of Live Earth, the hottest event this summer - only on MSN
http://liveearth.msn.com?source=msntaglineliveearthhm
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
top of the wing (top of tip horizontal spanwise) then the trailing edge
angles down if you sight along trailing edge of flaperon and tip. Fife's
instructions say to use a straightedge along the top of the wing and tip. I
like the look of a straight trailing edge, and think it will look funny if
the tips sag at the trailing edge. Has anyone else had this issue?
Thanks.
Jesse
_________________________________________________________________
Get a preview of Live Earth, the hottest event this summer - only on MSN
http://liveearth.msn.com?source=msntaglineliveearthhm
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------