The Murphy Builders Site

Spray can of 3M or similar contact cement works fine.

----- Original Message -----
From: "Richard E. Swan" <richardswan@conwaycorp.net>
To: <rebel-builders@dcsol.com>
Sent: Monday, June 04, 2007 10:55 PM
Subject: [rebel-builders] Adhesive for Aluminum

Hello builders:

Can anyone provide a suggestion on what adhesive is safe to use on 6061
aluminum? Anticipated usage is gluing on fabric for interior in spots.
Thanks,

Richard
Rebel #372R
Conway, Arkansas




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Hi Richard !

You can make it easier for updates, and a lot quieter, if you
get some plastic insulating bubble pack & glue the fabric to
it first - it might then friction-fit the spaces ....

The insulating bubble pack is available in rolls, used for
barns, etc. It's about 1/4" thick, with metal foil on both
sides of the plastic bubbles - very light, and a great
noise & heat buffer. Just wrap the fabric around one
or 2 layers of it, and glue down with spray contact
cement. Can also be velcro'd in place ...

--
......bobp
http://www.prosumers.ca
http://bpatterson.qhealthbeauty.com
http://apatterson2.qhealthzone.com

-------------------------------orig.-------------------------
On Tuesday 05 June 2007 02:55, Richard E. Swan wrote:

Hello builders:

Can anyone provide a suggestion on what adhesive is safe to use on 6061
aluminum? Anticipated usage is gluing on fabric for interior in spots.
Thanks,

Richard
Rebel #372R
Conway, Arkansas

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

To echo what Wayne said. I found two 3M's products "Super Trim Adhesive"
part #08090 and "Hi-Strength 90" #62-492-4930-3 work best. The others I
tried would not take the summertime temperature in side a closed cockpit.
The adhesive would turn almost liquid and release their hold.

Charlie E. 802R

----- Original Message -----
From: "Richard E. Swan" <richardswan@conwaycorp.net>
To: <rebel-builders@dcsol.com>
Sent: Monday, June 04, 2007 9:55 PM
Subject: [rebel-builders] Adhesive for Aluminum

Hello builders:

Can anyone provide a suggestion on what adhesive is safe to use on 6061
aluminum? Anticipated usage is gluing on fabric for interior in spots.
Thanks,

Richard
Rebel #372R
Conway, Arkansas




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------