Fus-39 and -40. Also the -25 to continue the side crease..since the door
panel has a crease in it. Looks stupid with Fus-25 blank.
I also bend up both sides of the Fus-39 so it stays flat. Makes bulkhead
placement so much easier...but I think you're past that part.
Wayne
----- Original Message -----
From: <bransom@dcsol.com>
To: <rebel-builders@dcsol.com>
Sent: Sunday, June 03, 2007 10:38 PM
Subject: [rebel-builders] creased Fus-39, Fus-40 ?
Hi all,
Made good progress (and good product) this wknd after the consternation of
aligning front cage last week.
So now am considering creasing Fus-39 and Fus-40 (and Fus-25). I can
get
to a bending brake this week. How much up angle is good in the brake to
get the crease? I guess I'll know after trying on scrap, but if any hints
out there?
Thanks, as always,
-Ben/R-496
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------