MOOSE: Aileron travel
Posted: Sun Feb 19, 2012 12:04 pm
I read through what I could find on the list regarding the controls for the
moose/2500. My manual indicates that the angle between vertical and the
horn for the torque tube is 50 degrees. Apparently there has been some
variation here, others indicated 54 degrees. When I move the stick left and
right I see interference between the push rod and the horn of the torque
tube as it pushes the horn forward. I do not get full travel!
The next issue is what is full travel? I cannot find in the manual what the
travel of the aileron should be? What are others seeing?
Rick Muller
(303) 664 9219 Home
(303) 641 6623 Cell
rickhm@comcast.net
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
moose/2500. My manual indicates that the angle between vertical and the
horn for the torque tube is 50 degrees. Apparently there has been some
variation here, others indicated 54 degrees. When I move the stick left and
right I see interference between the push rod and the horn of the torque
tube as it pushes the horn forward. I do not get full travel!
The next issue is what is full travel? I cannot find in the manual what the
travel of the aileron should be? What are others seeing?
Rick Muller
(303) 664 9219 Home
(303) 641 6623 Cell
rickhm@comcast.net
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------