Elite - SR/Moose Drooped Wing tips
Posted: Sun Feb 19, 2012 12:04 pm
Mike,
Nice to see the fly-over picture of your Elite on your website ... very
nice.
Yesterday I was fitting the extended drooped tips, and discovered the chord
of the drooped tip is about an inch or so longer then the cord of my Elite
wing w/ aileron. My thoughts are to remove trailing edge material from the
tip between where the trailing edge of the aileron is and the existing
outboard trailing tip. And then glass what's left back together. Did you
run into this same issue ?? Is the chord on the Elite smaller then on the
SR and Moose? ... thought they were the same.
Cheers, Bob 612e
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Nice to see the fly-over picture of your Elite on your website ... very
nice.
Yesterday I was fitting the extended drooped tips, and discovered the chord
of the drooped tip is about an inch or so longer then the cord of my Elite
wing w/ aileron. My thoughts are to remove trailing edge material from the
tip between where the trailing edge of the aileron is and the existing
outboard trailing tip. And then glass what's left back together. Did you
run into this same issue ?? Is the chord on the Elite smaller then on the
SR and Moose? ... thought they were the same.
Cheers, Bob 612e
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------