cabin floor
Posted: Sun Feb 19, 2012 12:04 pm
Hello
When I made the fuselage inner floor, I used the "lexan technic" instead of put the
inner floor on the outer skin for holes matching. For the cabin floor, the sheet
are different (3 pieces vs 1 piece), the inner floor is longer at the cabin front,
and therei is a angle (inner always shorter than outer), could I use the "hole
matching technic" or it is better to use the "lexan one"?
p.s.: french to english translation could be "funny"...
Jean
Rebel 747R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
When I made the fuselage inner floor, I used the "lexan technic" instead of put the
inner floor on the outer skin for holes matching. For the cabin floor, the sheet
are different (3 pieces vs 1 piece), the inner floor is longer at the cabin front,
and therei is a angle (inner always shorter than outer), could I use the "hole
matching technic" or it is better to use the "lexan one"?
p.s.: french to english translation could be "funny"...
Jean
Rebel 747R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------