The Murphy Builders Site

Hello Bob,

I think that bearing was an optional support that someone came up with. I
don't think there's a service bulletin on it. You might check Scott
Aldrich's site at www.goflyamoose.com and look under completions to see if
there are any pictures of this modification.

Ted

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Robert
Johnson
Sent: Tuesday, March 20, 2007 6:59 AM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] Aileron Tip Support

I had seen on the Murphy site (before it was changed) a bearing support
added on the wing tip rib to support the outboard end of the aileron spade:
Can anyone advise if this is necessary or was this before the wing tip hinge
support modification. Thanks. Bob J Moose 226 (RH wing almost complete)



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------