Rudder horn drill template
Posted: Sun Feb 19, 2012 11:55 am
G'Day All, I'm at the rudder /elevator assy stage and was trying to
figure out how to drill the end plugs and not hit the nut plate. Then
the penny dropped and I made a perspex/lexan template off the rudder
horn. Nice and simple, and you can see what you are doing.
I've uploaded a pic in the rudder section of the files.
I know I have found lots of help from the list, so if this
is if use to some one at that stage of their build that's good.
Regards
John Gleeson.
Rebel 804 down under.
PS ignore the large 1/4" hole, it was there in the scrap piece of lexan
to start with.
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
figure out how to drill the end plugs and not hit the nut plate. Then
the penny dropped and I made a perspex/lexan template off the rudder
horn. Nice and simple, and you can see what you are doing.
I've uploaded a pic in the rudder section of the files.
I know I have found lots of help from the list, so if this
is if use to some one at that stage of their build that's good.
Regards
John Gleeson.
Rebel 804 down under.
PS ignore the large 1/4" hole, it was there in the scrap piece of lexan
to start with.
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------