The Murphy Builders Site

Hi Charlie !

You're right - you will want to add the extra row of holes for
attachment of the wing skin, outboard of your new end rib
position - #2 . You can then trim the tank skin down to the
smaller size - and save some weight ! :-)
This would mean cutting less of the wing skin away ...
and filling those extra skin holes with rivets later, I guess ...

--
......bobp
http://www.prosumers.ca
http://bpatterson.qhealthbeauty.com
http://apatterson2.qhealthzone.com

-------------------------------orig.-------------------------
On Sunday 18 February 2007 17:18, Charlie Eubanks wrote:

Hello All

I plan to certify my Rebel at 1320 Lbs. so I will only be using two tank
bays (15 Gal's) per side. I am getting ready to transfer the holes to the
tank covers from the wing skins which are pre-drilled to use all three tank
bays. I assume the preferred procedure would be to use the full size tank
covers and duplicate the two extra rows of holes at the tanks outboard rib
(#3)

Charlie E. 802R

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------