wing stringers
Posted: Sun Feb 19, 2012 11:43 am
Keith,
That is more than necessary. Just enough to allow fluid flow after the ProSeal is added, 5/16" - 3/8". That is on the wing with the flange turned out. The other wing takes care of itself as the stringer should not ride over the wing flange or vice versa.
Regards,
Ralph
PS - Another suggestion. Be sure to use nutplates to attach the flap/aileron hinges in lieu of nuts inside the wings.
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
That is more than necessary. Just enough to allow fluid flow after the ProSeal is added, 5/16" - 3/8". That is on the wing with the flange turned out. The other wing takes care of itself as the stringer should not ride over the wing flange or vice versa.
Regards,
Ralph
PS - Another suggestion. Be sure to use nutplates to attach the flap/aileron hinges in lieu of nuts inside the wings.
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------