bending aluminium..
Posted: Sun Feb 19, 2012 11:39 am
One of the Ontario mod is to replace ST-31 by ST-28 for the door frame... If I do it that way, I will be short of ST-28 later and I will have a
overstock of ST-31. Like I told before, I will make doubler out of .020" scrap material and double those sill. My question:
The "grain of the aluminium" in ST-31 is longitudinal, but if I use the "scrap" I have the grain of the doublers will be "in the other way"...
Because it is just a doubler, is it OK?
Jean
Rebel 747R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
overstock of ST-31. Like I told before, I will make doubler out of .020" scrap material and double those sill. My question:
The "grain of the aluminium" in ST-31 is longitudinal, but if I use the "scrap" I have the grain of the doublers will be "in the other way"...
Because it is just a doubler, is it OK?
Jean
Rebel 747R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------