Dynafocal engine mount
Posted: Sun Feb 19, 2012 11:38 am
I went up to the factory yesterday to pickup a dynafocal mount, high speed
cowl, windshield and assorted replacement parts (for parts that I
mangled...I mean didn't meet spec).
I just test fitted the dynafocal mount on the Elite firewall and the two
upper flanges on the mount appear to need a 1/8" to 1/4" trim for a snug
fit. These flanges overhang the firewall as-is.
I also looked a several pics of others' firewalls and it does look like
trimming or grinding is needed. Have other Rebel or Elite builders
experienced this?
Eric Fogelin
645E
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
cowl, windshield and assorted replacement parts (for parts that I
mangled...I mean didn't meet spec).
I just test fitted the dynafocal mount on the Elite firewall and the two
upper flanges on the mount appear to need a 1/8" to 1/4" trim for a snug
fit. These flanges overhang the firewall as-is.
I also looked a several pics of others' firewalls and it does look like
trimming or grinding is needed. Have other Rebel or Elite builders
experienced this?
Eric Fogelin
645E
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------