Page 1 of 1

[rebel-builders] Rebel Questions: tail wrap; engine fit; riveter modificati

Posted: Sun Feb 19, 2012 11:38 am
by Drew Dalgleish
At 07:02 PM 1/26/2007 -0800, you wrote:
Here is some interesting reading on VGs.
http://www.stolspeed.com/content.php?id=5

I use the landshorter.com (Harrison Designs) on my Rebel, and they lowered
my stall speed by about 10 mph, which surprised the heck out of me when I
did my first stall with them. No adverse handling effects and no change in
cruise speed. I didn't need them anywhere on the tail. I positioned mine at
10% chord and spaced them 3 inches apart.

On floats they did add more drag on my take-off (more lift = more drag, I
guess) if I started off with full flaps. As a result, I had to modify my
take-off technique to start with no flaps and then add full flaps after
building up some speed on the step, and then it pops right up.

I think an 0360 would help overcome that take-off drag, and could probably
utilize more float angle, too, with the VGs, to help further with the float
take-offs.

And not that a stock 0320 Rebel is any slouch on floats. But if you want the
ultimate...

Walter
if you want the ultimate Walter why not an 0-400 it weighs the same so
there's no reason not to. you like altitude so maybe a turbine would be a
better choice. ;o)
Drew



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------