[rebel-builders] fus 26
Posted: Sun Feb 19, 2012 11:35 am
The .032 is probably fine Jean...but if you want to make it even better
laminate the original to it as well and add a few rows of rivets to tie them
together between the bulkheads.
Wayne
----- Original Message -----
From: <jean.poirier@oxyportneuf.com>
To: <rebel-builders@dcsol.com>
Sent: Thursday, January 25, 2007 8:30 PM
Subject: [rebel-builders] fus 26
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
laminate the original to it as well and add a few rows of rivets to tie them
together between the bulkheads.
Wayne
----- Original Message -----
From: <jean.poirier@oxyportneuf.com>
To: <rebel-builders@dcsol.com>
Sent: Thursday, January 25, 2007 8:30 PM
Subject: [rebel-builders] fus 26
Hello
The second ontario mod... fus 26 remake off .032" or .040". I just
have .032" should I use just the new one or the .032" with the
original .020"?
Jean
Rebel 747R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------