The Murphy Builders Site

Hey all,
Last night I was working on fitting the tailspring bulkhead Fus-49 to
Fus-30. I get more gap than should be there on a couple of the lower
finger flanges left side of Fus-49 and the inside of Fus-30. I've nudged
the position of Fus-49 but don't want to play with that too much as MAM
calls out that 4 3/4" distance and it looks like it is supposed to be
parallel to the back fin post. I'm thinking of putting a shim (probably
032) spacer between those flange fingers that don't sit flush. This sound
reasonable?

<a href="http://mae.ucdavis.edu/ransom/Murphy/fu ... >Reference Pic</a>
Thanks
-Ben/ 496R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------