The Murphy Builders Site

Good job mike,
I am anticipating the creation of my own monster with a certain amount of
dread. I don't know much about electrical stuff. I do have the book though.
Do you think I can make an electrical system with limited knowledge, just
using the book and of course asking you guys lots of questions?
Jesse

From: "Jones, Michael" <Michael.Jones@snclavalin.com>
Reply-To: <rebel-builders@dcsol.com>
To: rebel-builders@dcsol.com
Subject: [rebel-builders] its alive !!!
Date: Tue, 28 Nov 2006 07:08:56 -0500

Its alive, finally put battery power to electrical system, did not work at
first cause stupid me mixed up starter and battery contactors, how dumb is
that, but after finding mistake hooked up battery, flipped master and
power,
gyros came on, low volt light cam on, finally a big step done, now just
check a few circuits and ready to build cowl



I highly recommend using aeroelectric connection book and its online
resources, wiring diagrams are great help, also b & c speciality for
electrical parts is great



Best thing I did was use aeroelectric method of marking all wires with
little pieces of paper and then clear heat shrink over top the paper line
numbers to protect them



Anyway may make rebel ramble yet



Mike#007









-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

_________________________________________________________________
Get free, personalized commercial-free online radio with MSN Radio powered
by Pandora http://radio.msn.com/?icid=T002MSN03A07001




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

You can follow wiring diagrams in aeroelectric book or drawings in eaa
books, both are good sources of info, eaa are very simple while aeroelectric
are much more advanced

To do wiring get good tools from b&c, label both ends of all wires, run one
wire at a time

Most important have a complete wiring schematic in front of you and mark off
as you do each wire

I use cad system at work so did my drawing and could plot as big as I want
I was thing of offering a service to do peoples wiring schematics and books,
not design for them but draw and compile it in a book done with cad system
so it looks good, you could be my first customer
If you go onto builders site under electrical-rebel I have posted examples
of over all schematics in PDF form, don't use it however it has mistakes

Mike#007

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Jesse
Jenks
Sent: Tuesday, November 28, 2006 11:59 AM
To: rebel-builders@dcsol.com
Subject: RE: [rebel-builders] its alive !!!

Good job mike,
I am anticipating the creation of my own monster with a certain amount of
dread. I don't know much about electrical stuff. I do have the book though.
Do you think I can make an electrical system with limited knowledge, just
using the book and of course asking you guys lots of questions?
Jesse

From: "Jones, Michael" <Michael.Jones@snclavalin.com>
Reply-To: <rebel-builders@dcsol.com>
To: rebel-builders@dcsol.com
Subject: [rebel-builders] its alive !!!
Date: Tue, 28 Nov 2006 07:08:56 -0500

Its alive, finally put battery power to electrical system, did not work at
first cause stupid me mixed up starter and battery contactors, how dumb is
that, but after finding mistake hooked up battery, flipped master and
power,
gyros came on, low volt light cam on, finally a big step done, now just
check a few circuits and ready to build cowl



I highly recommend using aeroelectric connection book and its online
resources, wiring diagrams are great help, also b & c speciality for
electrical parts is great



Best thing I did was use aeroelectric method of marking all wires with
little pieces of paper and then clear heat shrink over top the paper line
numbers to protect them



Anyway may make rebel ramble yet



Mike#007









-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

_________________________________________________________________
Get free, personalized commercial-free online radio with MSN Radio powered
by Pandora http://radio.msn.com/?icid=T002MSN03A07001




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------