Elite trim wiring
Posted: Sun Feb 19, 2012 11:20 am
Anyone have a good solution to bringing the Elite trim wiring from inside the front "D" section of the elevator to the center and up past the stabilizer rear edge inside the fin / stabilizer fairing? My best so far is to file out a clearance in both elevator and stabilizer at top to eliminate a shearing action on the wire as full up elevator is approached. The clearance filing would be just to left of center hinge.
Thanks,
Ralph Baker
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Thanks,
Ralph Baker
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------