tail ontario mods.....
Posted: Sun Feb 19, 2012 11:20 am
Hello
I am finishing the floor in the fuselage (tail cone section). For the
modifications on the tail, 1- I should double the fus-30.. Bob told in
the past to make a second one and "glue" it the original with a lot of epoxy
primer and rivets. In the file section, the picture of one fix by Wayne
show just a "rear wrap" (+/- 50% of the surface) not a full part. did I mist
something? 2- The tail post doubler as in the file ( Which thickness?)
3- I did remember someone told me to make a doubler on the top skin where
the fin attach.. Is it all or something else in that area?
Jean
Rebel 747R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
I am finishing the floor in the fuselage (tail cone section). For the
modifications on the tail, 1- I should double the fus-30.. Bob told in
the past to make a second one and "glue" it the original with a lot of epoxy
primer and rivets. In the file section, the picture of one fix by Wayne
show just a "rear wrap" (+/- 50% of the surface) not a full part. did I mist
something? 2- The tail post doubler as in the file ( Which thickness?)
3- I did remember someone told me to make a doubler on the top skin where
the fin attach.. Is it all or something else in that area?
Jean
Rebel 747R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------