The Murphy Builders Site

Why not use an anchor nut (e.g. A6195-6Z-1D)?

Al

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
Ted Waltman
Sent: October 2, 2006 12:19 PM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] Rivnut dimple for access covers


I just uploaded two pictures of access covers that I have where they
have been dimpled for rivnuts. I've looked all over the web and can't
find any tool that creates these large dimples for rivnuts. Has anyone
on the list seen such a tool to create these rivnut dimples or is this
some totally custom deal that someone made?

The pics are in area 123 S/M Miscellaneous.

Thanks in advance...

Ted




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------







-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Hi Ted,

We used flush, keyed rivnuts on the bottom skin of our wing. We had to
dimple the wing skin. This allowed the access covers to fit flush on the
skin. We used round headed screws and the covers were not dimpled. Our goal
was not flush fasteners just covers that laid flat to the skin. We used a
hand squeezer and I know we had to find larger dies that would work.

Now, the bad news. I can't remember if we purchased them or we made them.
It's been a while and that part of the hard drive has been written over. The
next time I am out to the hanger (it may be a week or so) I will try and
locate the dies and get back to you. I will also email my partner and ask
him if he remembers.

Regards,
Don Boardman
Randy Bowers
Moose #130 M-14-PF 400HP MT 102" Beta Aerocet 3400 amphibs
Delta Lake
Rome NY

From: Ted Waltman <tedwaltman@i1ci.com>
Organization: IFC
Reply-To: rebel-builders@dcsol.com
Date: Mon, 02 Oct 2006 10:19:01 -0600
To: rebel-builders@dcsol.com
Subject: [rebel-builders] Rivnut dimple for access covers

I just uploaded two pictures of access covers that I have where they have
been dimpled for rivnuts. I've looked all over the web and can't find any
tool that creates these large dimples for rivnuts. Has anyone on the list
seen such a tool to create these rivnut dimples or is this some totally
custom deal that someone made?

The pics are in area 123 S/M Miscellaneous.

Thanks in advance...

Ted




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------