The Murphy Builders Site

Hi:
MAM states the lower engine mount holes are to be 23/32 " up from the
bottom of the firewall. When I place FUS 85 & 86 bolted together on the floor
on top of the .032 gusset I have 5/8 "- should I put a shim under the FUS
85/86 to bring it up to 3/4?? Thanks for the help.

Ken



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Be sure to make the .032 gusset extra long so the rudder pedal blocks (left
side is longest) will set on it.
http://n254mr.com/gallery2/v/254R/Build ... S.JPG.html
I would skip the shim. It is best to have the mount on hand to match the
holes.

On 9/10/2006 8:18 AM, ken wrote to Murphy- Builders:

-> Hi:
-> MAM states the lower engine mount holes are to be 23/32 " up from the
-> bottom of the firewall. When I place FUS 85 & 86 bolted together on the
floor
-> on top of the .032 gusset I have 5/8 "- should I put a shim under the
FUS
-> 85/86 to bring it up to 3/4?? Thanks for the help.
->
-> Ken





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------