[rebel-builders] Rudder Trim - Elite
Posted: Sun Feb 19, 2012 11:08 am
Thanks for the update Al, I will put this in my archive.
Mike Betti
----- Original Message -----
From: "Alan Hepburn" <ahepburn@xplornet.com>
To: <rebel-builders@dcsol.com>
Sent: Monday, September 04, 2006 3:20 PM
Subject: [rebel-builders] Rudder Trim - Elite
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Mike Betti
----- Original Message -----
From: "Alan Hepburn" <ahepburn@xplornet.com>
To: <rebel-builders@dcsol.com>
Sent: Monday, September 04, 2006 3:20 PM
Subject: [rebel-builders] Rudder Trim - Elite
I just added a fixed rudder trim tab to my Elite, and can report that it
now cruises with the ball centered. It was previously out by 1 to 1 1/2
ball widths, and took a fair amount of boot to correct - more than I'd
want to compensate for with the springs. The tab is 7" x 2 1/4",
deflected 1" at the trailing edge, and attached at the centre rib
station.
Al
-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------