Rudder Building

[Rich Dodson]

Gents,

Well, the first subkit has arrived, and I figure that I will start the process with the rudder. I searched the archives and came up with very little on rudder construction. Before I leap off the diving board here I was wondering:

a. I have not seen any night position (tail) lights on the rudder of the two dozen completed plane photos I have looked at. What have most folks done in terms of preparing for a later tail light installation?

b. Any other hints or tips I need before starting on this subassembly?

Thanks in advance!
Rich
806R




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[rognal]

Rich,

I uploaded a drawing to the file archives section 203-R-Rudder with a tip
regarding installation of the end plugs into the spar tubes. Hope this helps.

R. Hoffman #687R
Eugene, OR USA!

On 8/3/2006 12:43 PM, r_dodson@yahoo.com wrote to rebel-builders:

-> b. Any other hints or tips I need before starting on this subassembly?






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------