primer curing time
Posted: Sun Feb 19, 2012 11:00 am
I wonder if there is a way to spread on epoxy just before joining parts
without it curing before the parts are all riveted up.
Generally I haven't been too fussy about this because the joined parts keep
air off the epoxy and mostly keep it from drying (curing). But it is a
limitation on larger assemblies that take awhile, and even more so now with
the hotter weather. Any solutions? BTW, I've been using EP-420, but just
called to get info on Sherwin Williams stuff others mentioned here in the
archives.
-Ben
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
without it curing before the parts are all riveted up.
Generally I haven't been too fussy about this because the joined parts keep
air off the epoxy and mostly keep it from drying (curing). But it is a
limitation on larger assemblies that take awhile, and even more so now with
the hotter weather. Any solutions? BTW, I've been using EP-420, but just
called to get info on Sherwin Williams stuff others mentioned here in the
archives.
-Ben
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------