The Murphy Builders Site

Received: from JimsRebel@aol.com
by imo18.mx.aol.com (IMOv13.ems) id GHAGa14951
for <murphy-rebel@dcsol.com>; Wed, 8 Apr 1998 19:44:08 -0500 (EDT)
From: JimsRebel <JimsRebel@aol.com>
Message-ID: <1c6fec32.352c0bcd@aol.com>
Date: Wed, 8 Apr 1998 19:44:08 EDT
To: murphy-rebel@dcsol.com
Mime-Version: 1.0
Subject: Re: Tank drain holes, aileron hinge insp. holes, control horn
center hole
Content-type: text/plain; charset=US-ASCII
Content-transfer-encoding: 7bit
X-Mailer: AOL 3.0 for Windows 95 sub 49

After reviewing my notes in the fuel tank assembly chapter, the directions
don't include the sump drain (CAV-110 & W-159). The part is included in the
kit but not addressed in the manual. This must go on the bottom of the skin,
lower in-board corner. W-159 must be rivetted to the bottom of the skin to
allow the sump to drain properly.This can be done after the aircraft is
done.
Also be sure to vent the tanks with RAM air as per Murphy's new tech
article
"fuel tank cross venting" which is on there web page.
Jim LePard, Rebel 254



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------