The Murphy Builders Site

hi all

does no body know a k & n part number to replace the reel stock foam filter
??

mike#007




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

I do indeed have a K&N on our Elite. It is mounted in a Van's O-360 air intake box. It was used because I have had good experience with K&N's on motorcycles and trucks. As a big plus, the Van's airbox filters all the air including carb heat air. The filter is a large round unit and should offer much less restriction than stock.

Now the bad news. The Van's airbox will require a "bump" on the left side of the speed cowl for clearance as well as some creativity to mate it to the square MAM air intake area. Our solution will be to graft a Van's air intake onto the bottom of the speed cowl for clearance. It will add a larger and better shaped hot air exit as well. Probably will add at least 50 knots of airspeed in addition to the extra build hours.
Ralph Baker



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Can anyone advise me on what they are using for an air filter on a Moose with the M-14P engine?? ?
Have MAM's cowl.

Have to install one on and and need some help.

Thanks

Steve H
Moose 213



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------