The Murphy Builders Site

Before getting my methods figured out (the educational part, you know), I
slightly stretched the edge of one of my fuse corner wraps when trimming off
the edge (long edge, where it rivets to side skin). Can this be taken out with
a shrinker stretcher without marring the surface? I used an old shrinker-
stretcher once before, and although it did the job, it marred the surface
some. I'm wondering if a nicer tool would do the trick or am I better off just
getting another corner wrap. (i'm running low. ;-) )
-Ben



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------