Warp drive prop bolts
Posted: Sun Feb 19, 2012 10:47 am
Does anyone actually torque warp drive AN6 prop bolts to 35 lb-feet like
Warp Drive specifies?
That is over twice what an AN6 would normally be torqued to and it sure
doesn't feel right to go that high.
This is with hardened washers, fender washers, a UHS fibreglass spinner
backing plate, and a crush plate.
I don't have drive lugs but it is a gear driven prop - not a Lycoming
Ken
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Warp Drive specifies?
That is over twice what an AN6 would normally be torqued to and it sure
doesn't feel right to go that high.
This is with hardened washers, fender washers, a UHS fibreglass spinner
backing plate, and a crush plate.
I don't have drive lugs but it is a gear driven prop - not a Lycoming
Ken
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------