The Murphy Builders Site

Anyone have a source for the nut plates for the aileron hinges?

Thanks
Allen Poulsen
786R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

vansaircraft.com or aircraftspruce.com both work. I didn't bother with
floating nut plates but you will need single lug for these locations. I used
solid an3 flush rivets to tie the nutplates to flat stock first, and then these
are picked up with some of the other regular hinge plate 4010 rivets (pics at
http://mae.ucdavis.edu/ransom/Murphy/10.05). Not sure how typical this is,
but I wanted to do it in way that I could repeat later when I retrofit the right
wing. (didn't know about this tip when I did right wing)
-Ben

On 5/1/2006 2:44 PM, apoulsen@comcast.net wrote to rebel-builders:

Anyone have a source for the nut plates for the aileron hinges?

Thanks
Allen Poulsen
786R

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

meant to say .................. regular hinge plate 1410 rivets
-B

are picked up with some of the other regular hinge plate 4010 rivets (pics at

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------