[rebel-builders] source for metal
Posted: Sun Feb 19, 2012 10:38 am
U talking the 2" floor channel. It's just .020 sheet cut in approx 3 1/4"
strips and then the edges bent to give the 5/8 flanges. Nobody is going to
stock that other then MAM if you want it premade.
Wayne
----- Original Message -----
From: "David L. Tuck" <dltuck53@hotmail.com>
To: <rebel-builders@dcsol.com>
Sent: Monday, April 03, 2006 4:17 PM
Subject: [rebel-builders] source for metal
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
strips and then the edges bent to give the 5/8 flanges. Nobody is going to
stock that other then MAM if you want it premade.
Wayne
----- Original Message -----
From: "David L. Tuck" <dltuck53@hotmail.com>
To: <rebel-builders@dcsol.com>
Sent: Monday, April 03, 2006 4:17 PM
Subject: [rebel-builders] source for metal
stockHi all:
can anyone tell me is there a source to purchase metal as in the st31
other than mam ? I don't see that stock in Wicks or aircraft spruce ? Any
help here?
Thanks Dave T. in Mi. rebel 009
-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------