gear leg did they up the size??
Bill
Moose 244
----- Original Message -----
From: "Steve Halvorsen" <shalvorsen@sbcglobal.net>
To: <rebel-builders@dcsol.com>
Sent: Tuesday, March 21, 2006 7:58 PM
Subject: [rebel-builders] Moose Main Gear
Everyone that is working on or installed the 309's or the 309B's mounting
brackets into their Moose should check and MAKE SURE that the thru bolts
are 3/8 Dia.
The oridginel bolts were 5/16 Dia. MAM made a change to the size of the
bolt because of a seperation of a nut and bolt a few years back.
If you have the 5/16 Dia bolts in, remove them and drill and ream the
existing holes out to 3/8 Dia. Replace the 5/16 bolts with 3/8 bolts.
You will also have to enlarge the holes in the wrap so you can get the 3/8
bolts in and also to be able to get a socket onto the head of the bolt.
Steve H
Moose 213
-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
