The Murphy Builders Site

This is my first time attempting to post a message on this site, so forgive
my ignorance if I have done so improperly.

I am building a Moose, and am ready to close up my first wing. However, I
am now concerned that I may have been a bit over zealous in my zinc
chromating. I have chromated all the surfaces inside the wing, not simply
mating surfaces. This includes the inside of the tank skins, the ribs
within the tank, etc. Is this a problem? My concern is whether the zinc
chromate will withstand the prolonged contact with the fuel (I have not
chosen my powerplant yet, so I don't know if I will be running avgas or auto
fuel yet). Any thoughts on what may be a really stupid question are
appreciated.

Bill
SR199




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------