The Murphy Builders Site

Should I put a inner floor in rear fuselage area?

Except for sleeping.... For a structural purpose, is it a good thing? ...

Jean
Rebel747R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Hello,

Today is the first day back in the shop since may... good feeling!

I am on section 12.2 "INNER FLOOR CHANNEL INSTALLATION". The manual ask
for "the channels at the side should face inward and butt up to the flanges
of FUS-23-2 (bottom skin). I will try to explain my problem with my %$(&
english!

The outside corner wrap is already cleeco to the bottom skin with 3/32" as
per manual. If I put the channel (ST-31) facing inside, the line of rivet
of bottom skin and corner wrap will be, in my opinion, to close of the ST-31
radius. Should the rivet be for outside corner wrap/bottom skin/ST-31
channel all together? If so, could I put ST-31 facing outside (much
easier to center wiht the line of rivets already done). Did I made
something wrong?

Jean
Rebel 747R





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------