[rebel-builders] Re: [rebel-builders-d] DIGEST - rebel-build
Posted: Sun Feb 19, 2012 10:26 am
Hello All
Builder of Rebel 505
I am a carpenter by trade. Never worked with sheet metal. I found that if I
read the manual there was not a great big problem. Sure there were times
when a little reasurance was needed but generally all went well. With no
snags on my inspection reports shows there isn't a whole lot wrong with the
manual. Not perfect but also not bad enough that I wrecked any parts due to
misleading information.
The Moose it seems is a different animal.
Good luck to all.
Murray Cherkas
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Builder of Rebel 505
I am a carpenter by trade. Never worked with sheet metal. I found that if I
read the manual there was not a great big problem. Sure there were times
when a little reasurance was needed but generally all went well. With no
snags on my inspection reports shows there isn't a whole lot wrong with the
manual. Not perfect but also not bad enough that I wrecked any parts due to
misleading information.
The Moose it seems is a different animal.
Good luck to all.
Murray Cherkas
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------