Elite
Posted: Fri Feb 17, 2012 5:39 pm
What did you folks that are building a Elite, do with the dimpleing on the
horizontal for the stab and fin fairing. The diagram shows the dimpling
going clear to the trailing edge in the center section! however the last
two rows of rivits have the doubler ST326 on the outside. This doubler
doe's not lend itself to dimpling?
Doug Martin
greyghost@powernet.net
*----------------------------------------------------*
The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*----------------------------------------------------*
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
horizontal for the stab and fin fairing. The diagram shows the dimpling
going clear to the trailing edge in the center section! however the last
two rows of rivits have the doubler ST326 on the outside. This doubler
doe's not lend itself to dimpling?
Doug Martin
greyghost@powernet.net
*----------------------------------------------------*
The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*----------------------------------------------------*
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------