The Murphy Builders Site

Thanks Wayne, I forgot about your setup. It sounds like I should set to
around 20 degrees down and pre-load the cable a little before drilling
the cable guide. I can add another notch later if needed.

Clay

Ummmm..... you do know that 18 degrees down is the maximum that
the factory recommend for the Rebel, eh Clay ??!!
There are only 2 flap supports .....

If you go with 18, you might be able to get the 2 notches of
negative - all positions are supposed to be 6 degree increments.
Each notch of negative should give 2-3 mph more cruise - and a
better ride in turbulence.
.......bobp

-------------------------------orig.-------------------------
On Sunday 29 January 2006 08:18 pm, Clay Smith wrote:

Thanks Wayne, I forgot about your setup. It sounds like I should set to
around 20 degrees down and pre-load the cable a little before drilling
the cable guide. I can add another notch later if needed.

Clay

-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------