Page 1 of 1
Windows
Posted: Sat Feb 18, 2012 2:33 pm
by Mike Betti
Before I rivet my windows in the doors, is it necessary to have some sort of
sealant in there between the lexan and the outer piece?
Mike Betti
771E
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------
Windows
Posted: Sat Feb 18, 2012 2:33 pm
by Ken
No.
Mike Betti wrote:
Before I rivet my windows in the doors, is it necessary to have some sort of
sealant in there between the lexan and the outer piece?
Mike Betti
771E
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------
Windows
Posted: Sun Feb 19, 2012 8:50 pm
by Kelly M. Ewing
Hi all, question on the windows ( side windows not the windshield ), I'm riveting the acrylic between two pc of aluminum and have been told to oversize the hole in the acrylic and put bushing's in each hole then rivet.
I understand the oversize holes, however I think the bushing's are overkill.
Does somebody want to give me some advice?
Greatly appreciated.
Kelly ( Moose )
kelly@tru-form.ca
Enjoy your day !
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------