Flap cable
Posted: Sat Feb 18, 2012 2:33 pm
Sorry forgot the subject line.
On Wed, 14 Dec 2005 09:29:00 -0500, rebel-builders@dcsol.com said:
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
On Wed, 14 Dec 2005 09:29:00 -0500, rebel-builders@dcsol.com said:
Hi all,
I guess I don't quite get the instructions. To adjust the flap cable properly, where should the travel end up when looking at the mixer, as far as distance left in the slot above and below the moving arm? That is when moving the flap lever full or no flaps.
Thanks,
Mike Betti
771E
-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------