Elite Fin
Posted: Sat Feb 18, 2012 2:23 pm
Hi group,
I am getting close to putting the rudder on the fin and see I have to notch out the fin spar to clearance the rudder control horn. Does anyone know how much has to be cut out as far as depth goes? Knowing this might prevent me from taking too much off.
Thanks,
Mike Betti
771E
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
I am getting close to putting the rudder on the fin and see I have to notch out the fin spar to clearance the rudder control horn. Does anyone know how much has to be cut out as far as depth goes? Knowing this might prevent me from taking too much off.
Thanks,
Mike Betti
771E
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------