The Murphy Builders Site

When I put a drill rod through the hinges on my fastbuild Moose rudder I
find that they are not aligned with the axis of the spar or each other. One
pair of them is already drilled to .25" What should I do?

Thanks!

Mike
North Idaho.




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Peg top and bottom, top and middle, middle and bottom and note which pair
gives the least mis-alignment for the unpegged hinge. Ream the least
offender over size for -5 bolt or 5/6 x 1/4 hat bushings and a 1/4 bolt.

Cheers,
Wayne

----- Original Message -----
From: "Mike Rapoport" <rapopor1@ix.netcom.com>
To: <rebel-builders@dcsol.com>
Sent: Tuesday, October 18, 2005 11:25 PM
Subject: hinge aliignment

When I put a drill rod through the hinges on my fastbuild Moose rudder I
find that they are not aligned with the axis of the spar or each other.

One

pair of them is already drilled to .25" What should I do?

Thanks!

Mike
North Idaho.




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------