The Murphy Builders Site

Hi group,
I been on break from the project since the EAA convention, getting back
on the project once again.
What is the trick or tool for deburing those rivet holes in the 2"
carrythroughs, can't get to the inside?
Thanks,
Mike Betti
Elite 771



-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Hi group,
I been on break from the project since the EAA convention, getting back
on the project once again.
What is the trick or tool for deburing those rivet holes in the 2"
carrythroughs, can't get to the inside?

Hello Mike:

The good news is: that there is a two-way deburring tool, Part Number
TD 004
at Aircraft Tool Supply http://www.aircraft-tool.com/shop/main.htm. I
am
sure other suppliers stock this item. Here is a direct link to the
ecatalog
page: http://www.aircraft-tool.com/shop/searc ... x?PageNo=2

I use these in 1/8 and 3/16. I found that chucking one of these baby's
in an
electric drill gets a bit aggressive. For ME, the safest way is to use
them
by hand with a couple of twists of the fingers. A bit tedious, but well
worth the effort. I have used them to debur inside of my carrythroughs,
uprights, torque tubes, floor channels and many, many other places
where
blind deburring is required.

The bad news is: that they are VERY, VERY expensive.

The good news is: that Wayne's suggestion is simple and cheap.

1/4 Peso worth.

Terry Dazey
Rebel 662
Bonney Lake, Washington
(25 miles south of Seattle)

Hi group,
I been on break from the project since the EAA convention, getting
back
on the project once again.
What is the trick or tool for deburing those rivet holes in the 2"
carrythroughs, can't get to the inside?

-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Duct tape a large file to a yard stick!

----- Original Message -----
From: "Mike Betti" <mbetti@up.net>
To: <rebel-builders@dcsol.com>
Sent: Sunday, August 28, 2005 5:29 PM
Subject: deburing

Hi group,
I been on break from the project since the EAA convention, getting back
on the project once again.
What is the trick or tool for deburing those rivet holes in the 2"
carrythroughs, can't get to the inside?
Thanks,
Mike Betti
Elite 771



-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------