The Murphy Builders Site

Hi
I made the fibreglass windshield retainer yesterday and it went well.
However the inside surface that was up against the windshield remains
very tacky. This is a new problem for me and I'm wondering if there is
any way to encourage that to harden. Any suggestions would be
appreciated. The outside surface that was exposed to air is OK. It is
warm here and very high humidity but there was obviously sufficient wax
in the 1 year old polyester resin to protect the outer surface from
moisture and let it harden.
thanks
Ken

I've found that often warming epoxies and resins that are slow to cure
helps. Use a normal hair dryer... a heat gun is usually to hot.

Mike

From: Ken <klehman@albedo.net>
Reply-To: <rebel-builders@dcsol.com>
To: rebel-builders@dcsol.com
Subject: Re: Fibreglass question
Date: Sun, 17 Jul 2005 22:19:22 -0400

Thanks Mike. After thinking about it for awhile, I reasoned that since
that surface was acting like laminating resin, I'd treat it that way. So
I painted a coat of resin on it and warmed it up. All is well now. I
don't know why it did that but I suspect the very high humidity around
here these days caused the problem.
Ken

Mike Davis wrote:

I've found that often warming epoxies and resins that are slow to cure
helps. Use a normal hair dryer... a heat gun is usually to hot.

Mike

-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Hi
I made the fibreglass windshield retainer yesterday and it went well.
However the inside surface that was up against the windshield remains
very tacky. This is a new problem for me and I'm wondering if there is
any way to encourage that to harden. Any suggestions would be
appreciated. The outside surface that was exposed to air is OK. It is
warm here and very high humidity but there was obviously sufficient wax
in the 1 year old polyester resin to protect the outer surface from
moisture and let it harden.
thanks
Ken




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------